Due to the current fluctuations in exchange rates and the impact of the recession on manufacturers, please regard the prices on this page as ‘guide’ only. If you are interested in the equipment you must contact me for a current price.
Power I Mk2 £5100
- Audiophile integrated stereo power amplifier with high output performance
- 8 selected MOS-FET output transistors of highest quality
- Magnetically shielded and encapsulated 550 VA toroidal core transformer
of premium quality ("Made in Germany“) for high output reserves;
separate windings for preamp section, for power amp section and for left
and right channel - Very good smoothing thanks to more than 80.000 µF power supply capacity
- Very high damping factor
- Integrated protective circuit switches ascents off when clipping,
HF oscillations or too high DC offset occurs - Constant low operating temperature due to generously dimensioned
heat sink integrated in housing - 3 x unbalanced inputs (RCA)/1 x balanced input (XLR)
- 2 x preamplifier-outputs (1 x balanced/1 x unbalanced)
- 1 x unbalanced input (RCA) configured as „SURROUND BYPASS“
Amp II Mk2 £8700
- Dual-mono high power amplifier with completely isolated power supply
for each amplifier channel - 24 selected MOS-FET output transistors of finest quality
- Magnetically shielded and encapsulated toroidal core transformer
of premium quality for highest output reserves - Maximum total transformer power: 2,200 VA (watts)
- Optimum smoothing thanks to over 160,000 µF power supply capacity;
Premium quality capacitors - Very high damping factor for perfect speaker control
- Professional protection circuit against clipping, HF oscillations and too high DC offset
- Integrated switch-on current limitation for highest operational safety
- Constant low operating temperature due to generously dimensioned heat sinks
- Balanced input (XLR) and unbalanced input (RCA) – the inputs are switchable
Pre Amp I Mk3 £3700
- Fully balanced premium preamplifier with professional extremely low distortion Class A
output stage using technology derived from studio engineering - Premium quality ICs: selected Burr Brown® OPA 627 and OPA 2107 only
- Magnetically shielded and encapsulated 75 VA toroidal core transformer of premium quality
for high output reserves - Circuit topology optimized for very short signal paths
- Extremely low distortion spectrum; e.g. K2=0.00007 %
- 3 x fully balanced inputs (XLR)/2 x unbalanced input (RCA)
- 1 x unbalanced input (RCA) configured as „SURROUND BYPASS“
- 2 x fully balanced outputs (XLR) e.g. for „Bi-Amping“ configurations
- 1 x unbalanced output (RCA) e.g for a separate subwoofer (active)
Amp I Mk2 £3800
- Audiophile stereo power amplifier with high output performance;
also suitable for less efficient, impedance critical and low ohm
loudspeaker systems up to 2 Ω - 8 selected MOS-FET output transistors of highest quality
- Magnetically shielded and encapsulated 600 VA toroidal core transformer
for high output reserves; separate windings for right and left channel - Very good smoothing thanks to more than 80.000 µF power supply
capacity; Premium quality capacitors (“Made in Germany”) - High damping factor for perfect speaker control
- Integrated protective circuit switches ascents off when clipping,
HF oscillations or too high DC offset occurs - Constant low operating temperature due to generously dimensioned
heat sink integrated in housing - Balanced input (XLR) and unbalanced input (RCA) – the inputs are switchable
Amp III £12200
- Dual-mono high-power amplifier with completely isolated power supply for each amplifier channel
- 48 selected MOS-FET output transistors of highest quality with a maximum power output of 1,000 watts per channel (4 ohms)
- Magnetically shielded and encapsulated toroidal core transformer of premium quality for highest output reserves
- Maximum total transformer power: 3,200 VA (1,600 VA per channel)
- Optimum smoothing thanks to more than 240,000 µF power supply capacity;
premium quality capacitors „made in Germany“ - Integrated protective circuit against clipping, HF oscillations and too high DC offset
- Very high damping factor
- Integrated switch-on current limitation for highest operational safety
- Perfect for Super-Audio CD® (SACD)
- Balanced XLR-inputs