Due to the current fluctuations in exchange rates and the
impact of the recession on manufacturers, please regard the
prices on this page as ‘guide’ only. If you are interested
in the equipment you must contact me for a current
price.
CS-300 Integrated Amplifier
£2100
The
CS-300 is equipped with Russian finest Tube EL-84 produced
by "SOVTEK" , which is well known for high sound quality
versus its small size.
For Driver circuit, we used GENERAL ELECTRIC 5751 (premium
version of 12AX7A) which has very stable and reliable
quality.
- TAPE MONITOR.
- HEADPHONE OUTPUT
- BASS BOOST SWITCH (+3dB & +5dB in the range below 100Hz.)
- SPEAKER/HEADPHONE SELECTOR.
- VARIABLE OUTPUT IMPEDANCE: 4/6/8 OHMS.
- 5 LINE INPUTS PLUS TAPE MONITOR
- TUBES: EL84/6BQ5(SOVTEK) X 4; 5751(G.E.) X 2
- OUTPUT POWER - STANDARD - 12W X 2
CS-300X(S) £2675
as above with:
• OUTPUT POWER - STANDARD - 15W X 2
• Tube Shield-Base: 24K gold plated.
• 24K Gold-Plated Knobs.
• SIDE-WOOD PANEL: Canadian White-Ash".
CS-600
Integrated Amplifier
£4600
By switching two selectors inside of the cabinet, you can
use either of 6L6GC or 6CA7 (EL34) , and LED indicators on
the front panel will show you which tube is
applied.
"PREAMP-IN" terminals on the rear panel allow you to use
CS-600 as a power amplifier.
By switching a selector on thr front panel, by-pass all the
functions only excepting a Volume control.
Multi output impedance selector: 4/6/8/16 ohms.
A wide-ranged and flat frequency response upto 100KHz is
enough capable for future digital audio format such as
SACD/HDCD.
- Twin-triode tube 6CS7 for the first-stage amplification.
- WBT type speaker terminals
- Heavy-duty output transformer for 50W grade amplifiers
- Large capacity choke-coil: 5H350mA
- Dumper tube 6CJ3 (for Colour TV use) is applied to delay a supply of high voltage (B-Voltage) to output tubes in order to protect output tubes from damages and to longer the life
- All high-end audio grade electrical components (condensors, resistors)
- Operation lamp indicator
- Succeeding a front design of CS-300/CS-300X
- 24K Gold-Plated Knobs
- Side Wood-Panels
- CS-600X IS EQUIPPED WITH 5 LINE INPUTS (RCA unbalanced) PLUS TAPE MONITOR.
- Power Amp Direct Switch. (All functions by-pass only excepting Volume control)
- Muting Switch
- Stereo/Reverse Switch
- Variable Output Impedance: 4/6/8/16 Ohms
- Tape Monitor Switch
- Bass Boost Switch
- Headphone Output
- Speaker/Headphone Selector Switch
- Tube Indicator Lamps
- Operation Lamp Indicator
CS-660P £6950
TWO CHOICES OF OUTPUT TUBES: KT-66 AND OPTIONAL 6CA7 (EL34)
By
switching two selectors inside of the cabinet, you can use
either KT-66 or 6CA7 (EL34) KT-66 or 6CA7 (EL34) KT-66 or
6CA7(EL34)KT-66 or 6CA7 (EL34) , a LED indicator at the
foot of each tube will change its colour and show you which
tube is in use. You also can use several other tubes of
different sound characterisic.
STEREO/MONO
SELECTOR SWITCH
You can use CS-660P as a monaural power amplifier by
changing the selector switch giving an 80W output
power.(40W x 2 when used as a stereo power amp.)
A
WIDE RANGE OF SPEAKER APPLICATION
Multi output impedance selector: 4/6/8/16 ohms.
FLAT
AND WIDE FREQUENCY RESPONSE
A wide frequency response from 10Hz to 100KHz (-0dB) caters
for digital audio formats such as SACD/HDCD.
OTHER
FEATURES
- Twin-triode tube 6CS7 for the first-stage amplification.
- WBT type speaker terminals.
- Large capacity choke-coil: 400mA
- Dumper tube 6CJ3 (for Colour TV use) is applied to delay a supply of high voltage (B-Voltage) to output tubes in order to protect output tubes from damage and to increase tube life.
- All high-end audio grade electrical components (condensors, resistors)
- Operation indicator lights up when the tubes are warmed up.
- Wood Side-Panels.
- TUBES COMPLIMENT -
(4) KT-66, (EL34/6CA7 - Option)
(4) 6CS7
(1) 6CJ3
- OUTPUT POWER -
(Stereo/Mono Selector Switch)
Stereo
40W x 2 (KT-66) at 1KHz.
Monaural
80W X 1 (KT-66) at 1KHz.
RS-28CX £4850
RS-28CX is equipped with the CR type equalizer based on
GE(General Electric/USA) 12AT7 authorized by J.A.N.(Joint
Army & Navy) standard of US Army, and can reproduce a
very high quality and clear sound without adding any NFB.
To
avoid compromising on sound quality ,one of the solutions
we adapted to totally protect the sensitive CR type
equalizer from negative effects was to develop a separate
power supply unit. Likewise, some of the finest available
high-end audio components were selected for the RS28C to
keep the deflection of the RIAA curve below +/-0.3%.
Of
course, the phono equalizer is only one of the strengths of
the RS28C. Another notable feature is a very strong output
voltage created by the Dual-Triode Tube 6CG7 of General
Electric(USA) used for the line stage. Leben further
selected the best quality tubes out of these and
constructed a powerful SRPP type amplification which can
supply power amplifiers with a maximum 80V of clean output
signal. In considering the fact that output voltage of a
standard preamplifier is more or less 40V, the RS28C can
output about two times as much voltage, which will drive
power amplifiers with very low input sensitivity.
Likewise,
for using the RS28C with a high sensitivity power
amplifier, a 5-step attenuator is present in order to
eliminate residual noise from speakers.
Leben
also included two outputs (one fixed and one variable) in
order to cope with requirements for adding a Sub-Woofer.
RS-28CX
SPECIFICATIONS
- Tube compliment -
2 x 6CG7 (G.E.)
2 x 12AT7 (G.E.)
1 x 5Y3WGT
RS-100
£3150
"GENERAL ELECTRIC"(USA) High Output Tube 6CG7
The
line Amplifier Circuit consists of special selected
Dual-Triode Tube 6CG7(General Electric/USA) by SRPP system
to improve high-frequency range of the sound, and can
supply a strong signal of 52V to the power amplifier.
Hum
Noise Canceller Circuits
For lighting the heater of 6CG7 tubes, DC current(12V) is
applied to minimize the noise of heating, and additionally,
60V bias is applied to the heater to cancel the noise
caused from the heater.
Carbon Film Resistor
Leben dared to choose a custom-made Carbon Film Resistor of
+/-3% error margin to have a more natural and smooth sound
instead of normal Metal Film Resistor of +/-1% error margin
which makes the sound more hard and stiff.
Direct
Input Terminal
A direct input terminal goes directly to the volume control
to transmit a pure signal without passing via the contact
points of the selector switch, therefore, a superior result
is obtained when a phono preamplifier or a CD player is
used through the Direct Input.
**Leben applied for the direct input circuit a highest
audio-grade PCOCC-A shield wire produced by Oyaide Electric
Co to achieve a pure signal transmission.
Luxurious
Employment of highest-grade components
The
highest audio-grade components are used for all essential
parts:
• Super-precision German UXB resistor of 0.1% error margin.
• "EAO"(Germany) MKP Condensor
• "Nichicon" audio-grade condensor "Fine Gold"
• "ALPS" audio-grade volume for Volume and Balance
controls.
• "Spiral Wire" for all inner wiring(very near the single
structural wire)
Other
Features
• Two Outputs: One is Variable(with Volume level) and the
other is fixed.
• Five inputs plus Direct input.
• REC OUT/REC MONITOR IN
• Muting 30 minutes after Power-On.
• Natural wood Side Panels.
RS-100
SPECIFICATIONS
- Tube compliment -
2 x 6CG7 (G.E.) or 12AU7A(for RS-100U)
1 x 6X5GT (Sylvania)